1. Open the APP, click on "Start creating map,", than the APP interface will automatically switch to landscape mode, and the A1 will automatically check its status and calibrate.
2. After calibration is complete, remotely control the A1 to the edge of the lawn. In the APP, click "Set starting point" to determine the starting point of the boundary.
3. Remotely control the A1 starting from the set point, and walk around the edge of the lawn. The map outline will be displayed simultaneously on the APP.
4. When you have remotely controlled the A1 near the starting point, click on "Close outline" on the APP interface, and the map outline will be automatically completed.
Warm Tips: ①Make sure that the power of A1's battery is over 50% and ensure that your phone has established a Bluetooth connection with the A1.
② Confirm that the A1 is docked correctly in the charging station and is in standby mode. The lidar protective cover has been removed.
③ Do not create boundaries on slopes that exceed 27% (15°) where there is a risk of falling.
④ If your lawn is separated by a channel higher than 4 cm, place a ramp.
⑤ Avoid creating boundaries in corridors narrower than 1 meter.
⑥ During map creation, try to stay within 6 meters behind the A1.
⑦ If the height difference at the edge of your lawn exceeds 4 cm, keep the A1 at least 10 cm away from the lawn edge.
⑧ At corners, try to keep the turn angle greater than 90 degrees.